Reversible solid steel shank (Max. drop: 370mm / Max. rise: 350mm).
*Towball sold seperately
- Max. Gross Trailer Weight: 4500kg
- Max. Tow Ball Weight (Ball load): 450kg
- Weight 18kg
- Tested to comply with ADR62/02.
- Reversible solid steel shank (Max. drop: 370mm / Max. rise: 350mm).
- Shank has 3 pin holes to allow for additional set up configurations & lengths.
- Both the ball platform and the shank are fully reversible, providing 16 stages of adjustment.
- Compatible with either 50mm (3500kg, 7/8” dia. shank) or 70mm (4500kg, 1-1/4” dia. shank) tow balls.
- The included reducing bush (Fig. 3) & washer (Fig. 4) allows the fitment of standard 50mm (3500kg) tow balls.
- H.T. bolts, conical toothed washers & nyloc nuts for added strength & security.
- Ball platform features an anti-rattle Allen/Hex head screw (Allen/Hex key tool included).
- 25mm thick / 75mm wide, reversible ball platform for stronger ball loading.
- 25 year warranty.
- Powder coated enamel finish on shank & platform, while hardware is zinc plated to reduce corrosion.
- Compatible with most off-road couplings, including the following; Hitchmaster DO35 & DO45, McHitch,
Poly Block couplings (including Treg & Trigg), AL-KO, Hitch-Ezy & Ark.
- Insert the shank (1) into the tow bar receiver and fit the hitch pin (not included).
- Align the shank bolt holes with the ball platform bolt holes at the required height.
- Fit the 3/4” bolts (5), conical washers (6) and nuts (7) as seen in the diagram above, but do not tighten.
- Insert the anti-rattle Allen/Hex head screw (8) into the ball platform (2) and use the Allen/Hex key to tighten against the face of the shank. Do not over-tighten.
- Tighten both 3/4“ bolts to 339Nm (250ft lbs).
- If using a 50mm tow ball (7/8” dia. shank), you will need to insert the reducing bush (3) and washer (4) as seen in the diagram above. The reducing bush and washer are not required if using a 70mm tow ball.
